美國羅克韋爾光電編碼器，AB光電編碼器技術規格
8. Make the electrical connections according to the table
under “Electrical Connections.”
IMPORTANT: Wiring must be in accordance with the
National Electric Code and applicable local codes and
ordinances.
9. Apply the specified voltage (see Table “e” under
“Selection” on page 1 of this publication).
2.將編碼器滑到配合軸上，直到系帶座或防轉銷固定在機器表面上。
編碼器應在軸上自由滑動; 如果沒有，不。
檢查軸是否有干擾，如溝槽，毛刺，銹蝕或尺寸。
如果安裝孔或防旋轉銷止動件已經存在，則繼續執行步驟6。
3.標記安裝孔和/或防轉銷停止位置。
1. Loosen the screw on the clamping ring with a 3/32 inch
hexagon socket wrench.

美國羅克韋爾光電編碼器，AB光電編碼器技術規格
2. Slide the encoder onto the mating shaft until the tether
mount or anti-rotation pin rests on the machine surface.
The encoder should slide freely on the shaft; if not, do not
force. Check the shaft for interferences such as gouges,
burrs, rust or size.
If a mounting hole or anti-rotation pin stop already exists,
proceed to step 6.
3. Mark the mounting hole and/or anti-rotation pin stop
location.
4. Slide the encoder off. Drill and tap the marked hole to
accept the 0.375 inch x 16 (tether option B or C) or 0.5
inch x 13 (tether option A) bolt.
4.關閉編碼器。 鉆取并點擊標記的孔以
接受0.375英寸x 16（系繩選項B或C）或0.5英寸x 13（系繩選項A）螺栓。
高頻響應
盲軸和全通軸前端耦合型
不需要柔性耦合器
IMPORTANT: Do not stress the tether mount while
tightening the bolt.
7. Tighten the clamping ring to 8 inch-lbs.

，AB光電編碼器技術規格